SunStar Heating Products Infrared Ceramic Heater — Natural Gas, 100,000 BTU, Model# SG10-N

Product Summary

The SunStar Heating Products Ceramic Heater is ideal for spot heating or area heating of remote locations, farm buildings, shops, service areas, pump houses or other hard-to-heat spaces, providing both fuel efficiency of radiant heat and installation flexibility (not recommended for car washes). This is an energy-saving Direct Spark Ignition heater and can be controlled by a line voltage or 24V thermostat (sold separately). May require the following second stage regulators prior to the heater based on gas supply pressure: A regulator up to 2 PSIG line pressure or a regulator above 2 PSIG line pressure (both sold separately). NOT CERTIFIED OR APPROVED FOR RESIDENTIAL USE. Indoor use only. U.S.A.
NOTE: Please review the detailed Installation & Operating Instructions (attached) for other specific installation requirements (gas pressure, ventilation etc.) prior to purchasing the heater.

What’s Included

• (1) Infrared ceramic heater

Product Manual

Features + Benefits

• Constructed from aluminized steel for corrosion resistance and long life
• Aluminum reflectors are designed to maximize radiant efficiency
• Heaters can be angle mounted horizontally and up to 30 degrees
• The minimum mounting height is 15ft. above finished floor for uniform energy distribution and human comfort
• Requires the following clearances from any combustible material: 65in. above, 129in. below and 49in. from the sides of the heater

• The minimum supply gas pressure is 7.0in. Water Column (WC) and the maximum supply pressure is 14in. WC gas pressure
• If higher gas pressure is supplied, you will need to install a line pressure regulator (sold separately) to reduce it to less than 14in. WC (or 1/2 PSIG)
• No assembly required
• Heaters are 100% test-fired prior to shipment
• CSA design certified

Key Specs